vand amplificator Infinity Kappa 54a made in the USA cu specificatiile de mai jos:
K A P P A 5 4 A . . .
Power Output, 4 ohms: 4 x 50 watts (rms)
Power Output, 2 ohms: 4 x 75 watts (rms)
Power Output, Bridged 4 ohms: 2 x 150 watts (rms)
Frequency Response: 20 Hz ~ 20 kHz
Input Sensitivity: 250 mV ~ 9 V
THD + Noise (4 ohms): 0.05 %
Signal-to-Noise: > 95 dB
Maximum Current Draw: 40 A
Dimensions (w x h x l): 16 x 2 3 ⁄16 x 81 ⁄2 in.
406.4 x 55.6 x 215.9 mm
K A P P A 5 4 A A M P L I F I E R F E A T U R E S . . .
The Kappa 54a is a 4-channel power amplifier that offers
stereo, bridged-mono, or tri-mode operation, and is rated at
50 watts (rms) per channel into a 4-ohm load. In a bridgedmono
configurations, front and rear amplifiers can deliver
up to 150 watts (rms) for the same load. The 54a also
features:
2-ohm operation, rated at 75 watts (rms) per channel
Bridge/stereo switches for fast system setup
Built-in 12 dB-per-octave electronic crossovers, variable
from 32 to 320 Hz
Individually selectable high- and low-pass filters for all
outputs (with through-pass on amplifier outputs and
front/rear sum on auxiliary outputs)
Amplifier input sensitivity controls to match a wide
range of input signal levels from 250 mV to 9 V
Five protection levels guard against over-voltage, undervoltage,
over-power, over-temperature, and over-current
situations
2-color LED array indicates green when power is on and
orange when protection is activated
Industrial-grade, gold-plated, pre-wire and plug-in
connectors for an easy-to-install high-quality interface
Transparent control cover to deter tampering yet provide
a clear view of installation settings
Built-in automotive type fuses to protect the amplifier
Unibloc chassis provides improved heat-sink capacity
and exceptional RFI shielding characteristics
este un amplificator de foarte buna calitate, voi reveni cu poze reale.
Contact: 0751488830 sau id
alpine_clarion@yahoo.com
pret: 100 euro